Emeraude v2.60 – Doc v2.60.01 - © KAPPA 1988-2010
Guided Interpretation #7
•
B07 - 8/9
¾
Edit and change the slope/intercept values directly. This option is enabled only if the
display mode (TVD or MD) is the mode where the line was created.
¾
Modify the line interactively.
¾
Delete the current line and re-perform a Regression/Draw action.
¾
Use the ‘Regression’ option to compute the oil line -green- (from 3135 ft to 3160 ft); and
the water line –blue- (from 3160 ft to 3210 ft) in a similar manner. Selecting the ‘Good
only’ points for all lines should lead you to the following results:
Fig. B07.12 • Lines section for Oil and Water
Once at least two lines have been defined (on the same scale), Emeraude will automatically
compute their intersection and display the results under the ‘Contacts’ section:
O
il
G
as
C
ontact:
Fig. B07.13 • GOC Contacts section
W
ater
O
il
C
ontact:
Fig. B07.14 • OWC Contacts section
Annotations are automatically created to display the pressure gradient for each line and
contact depth values on the reservoir pressure view. Those annotations are moveable (right
click on top and edit) as seen in Fig. B07.15: