Emeraude v2.60 – Doc v2.60.01 - © KAPPA 1988-2010
Guided Interpretation #10 B10 - 4/12
¾
Define rate calculation zones interactively with
above and between the perfs. The
exact position is not so important (make sure that you do not overlap with perfs, and stay
within the data range).
Fig. B10.6 • TEMP, PPRE and TGEO display
3 inflow zones are identified, corresponding to the perforations. We see on the temperature log
that they are all producing. We can use this information now in the following manner:
¾
Double click on an inflow zone (white).
A grid pops up with the zones and a question mark in the ‘Inflow type’ column.
¾
Click on the question marks to set each zone to a producing zone and OK.
Fig. B10.7 • Inflow zones
¾
Click on ‘Inflow Rates’; the default is on ‘Single phase’ which is fine; click OK.